品牌
其他厂商性质
广州市所在地
400G CFP2 DCO Optical Transceiver Module
面议
100Gb QSFP28 ZR4 80Km 1310nm LC Optical Transceiver
面议
100Gb/s QSFP28 DWDM PAM4 Dual LC Transceiver
面议
100Gb/s QSFP28 DWDM Dual CS Adaptor Transceiver
面议
100GBASE-SR Bi-Directional QSFP28 850/900nm 100m DOM LC MMF Optical Transceiver Module
面议
100GBASE-LR Bi-Directional QSFP28 1280/1310nm 20km LC SM Optical Transceiver Module
面议
10G DWDM SFF 40km Transceiver -40℃ To 85℃
面议
100Gb QSFP28 ER4 40Km 1310nm LC Optical Transceiver
面议
100G QSFP28 LR4 1310nm 10km LC Optical Transceiver
面议
3G Video SFP Optical Transceiver support 1080P 60HZ Video
面议
3G Video CWDM SFP Optical Transceiver support 1080P 60HZ Video
面议
12G Video SFP+ Optical Transceiver support 4K 60HZ Video
面议
RSPD-03C150-XX
1.25Gb/s 150km SFP Transceiver Hot Pluggable, Duplex LC, +3.3V, 1270~1610nm, CWDM LD&APD, Single-mode, DDM
FIBERWDM’s RSPD-03C150-XX Transceiver is a high performance, cost effective module which have a duplex LC optics interface. Standard AC coupled CML for high speed signal and LVTTL control and monitor signals. The receiver section uses an APD receiver and the transmitter uses a CWDM DFB laser, up to 36dB link budge ensure this module 1000Base Ethernet 150km application.
Absolute Maximum Ratings
| Parameter | Symbol | Min. | Typical | Max. | Unit |
| Storage Temperature | TS | -40 | | +85 | °C |
| Supply Voltage | VCC | -0.5 | | 4 | V |
| Relative Humidity | RH | 0 | | 85 | % |
Recommended Operating Environment
| Parameter | Symbol | Min. | Typical | Max. | Unit | |
| Case operating Temperature | Industrial | TC | -40 | | 85 | °C |
| Extended | -5 | | 85 | °C | ||
| Commercial | 0 | | +70 | °C | ||
| Supply Voltage | VCC | 3.135 | | 3.465 | V | |
| Supply Current | Icc | | | 300 | mA | |
| Inrush Current | Isurge | | | Icc+30 | mA | |
| Maximum Power | Pmax | | | 1 | W | |
Electrical Characteristics(TOP= -40 to 85°C, VCC = 3.135 to 3.465 Volts)
| Parameter | Symbol | Min. | Typical | Max. | Unit | Note |
| Transmitter Section: | | |||||
| Input differential impedance | Rin | 90 | 100 | 110 | | |
| Single ended data input swing | Vin PP | 250 | | 1200 | mVp-p | |
| Transmit Disable Voltage | VD | Vcc – 1.3 | | Vcc | V | 2 |
| Transmit Enable Voltage | VEN | Vee | | Vee+ 0.8 | V | |
| Transmit Disable Assert Time | Tdessert | | | 10 | us | |
| Receiver Section: | | |||||
| Single ended data output swing | Vout,pp | 250 | | 800 | mv | 3 |
| LOS Fault | Vlosfault | Vcc – 0.5 | | VCC_host | V | 5 |
| LOS Normal | Vlos norm | Vee | | Vee+0.5 | V | 5 |
| Power Supply Rejection | PSR | 100 | | | mVpp | 6 |
Note:
1. AC coupled.
2. Or open circuit.
3. Into 100 ohm differential termination.
4. 20 – 80 %
5. LOS is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.
6. All transceiver specifications are compliant with a power supply sinusoidal modulation of 20 Hz to 1.5MHz up to specified value applied through the power supply filtering network shown on page 23 of the Small Form-factor Pluggable (SFP) Transceiver Multi-Source Agreement (MSA), September 14, 2000.
Optical Parameters(TOP= -40 to 85°C, VCC = 3.135 to 3.465 Volts)
| Parameter | Symbol | Min. | Typical | Max. | Unit | Note |
| Transmitter Section: | ||||||
| Center Wavelength | λc | λ-3 | λ | λ+3 | nm | |
| Spectral Width | σ | | | 1 | nm | |
| Side Mode Suppression Ratio | SMSR | 30 | | | dB | |
| Optical Output Power | Pout | +2 | | +5 | dBm | 1 |
| Extinction Ratio | ER | 9 | | | dB | |
| Optical Rise/Fall Time | tr/ tf | | | 260 | ps | 2 |
| Relative Intensity Noise | RIN | | | -120 | dB/Hz | |
| Output Eye Mask | Compliant with IEEE802.3 z (class 1 laser safety) | | ||||
| Receiver Section: | | |||||
| Optical Input Wavelength | λc | 1270 | | 1610 | nm | |
| Receiver Overload | Pol | -7 | | | dBm | 4 |
| RX Sensitivity | Sen | | | -34 | dBm | 4 |
| RX_LOS Assert | LOSA | -45 | | | dBm | |
| RX_LOS De-assert | LOSD | | | -35 | dBm | |
| RX_LOS Hysteresis | LOSH | 0.5 | | | dB | |
| General Specifications: | ||||||
| Data Rate | BR | | 1.25 | | Gb/s | |
| Bit Error Rate | BER | | | 10-12 | | |
| Max. Supported Link Length on 9/125μm SMF@1.25Gb/s | LMAX | | 120 | | km | |
| Total System Budget | LB | 34 | | | dB | |
Note
1. The optical power is launched into SMF.
2. 20-80%.
3. Jitter measurements taken using Agilent OMNIBERT 718 in accordance with GR-253.
4. Measured with PRBS 27-1at 10-12BER
Order Information:
| Part Number | Product Description |
| RSPD-03C150-27 | SFP, 1270nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-29 | SFP, 1290nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-31 | SFP, 1310nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-33 | SFP, 1330nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-35 | SFP, 1350nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-37 | SFP, 1370nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-39 | SFP, 1390nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-41 | SFP, 1410nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-43 | SFP, 1430nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-45 | SFP, 1450nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-47 | SFP, 1470nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-49 | SFP, 1490nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-51 | SFP, 1510nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-53 | SFP, 1530nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-55 | SFP, 1550nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-57 | SFP, 1570nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-59 | SFP, 1590nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
| RSPD-03C150-61 | SFP, 1610nm CWDM, 1.25Gbps, LC, 150km, 0°C~+70°C, with DDM |
