Applicable to: Industrial pipeline continuous production, cycle operations and remote automatic control. Rotor design: design and manufacture from single stage---II level---III level duality MBE300-1 type technical parameters Note: 1. The flow in the table is the data measured when the medium is “water”, and the flow rate of the materials will vary. 2. If the material has poor fluidity, it is recommended to feed the corresponding pump at the inlet. The pumping pressure is P≤0.2Mpa 3. The parameters in the table are subject to change without prior notice. The actual product shall prevail. 4. If a recycling process is used, it is recommended to use it in combination with a batch high shear dispersing emulsifier. 5. If there are high temperature, high pressure, flammable, explosive, corrosive and other working conditions, it is necessary to clearly provide relevant and accurate parameters for further selection and formulation. MBE300-II technical parameters Note: 1. The flow in the table is the data measured when the medium is “water”, and the flow rate of the materials will vary. 2. If the material has poor fluidity, it is recommended to feed the corresponding pump at the inlet. The pumping pressure is P≤0.2Mpa 3. The parameters in the table are subject to change without prior notice. The actual product shall prevail. 4. If a recycling process is used, it is recommended to use it in combination with a batch high shear dispersing emulsifier. 5. If there are high temperature, high pressure, flammable, explosive, corrosive and other working conditions, it is necessary to clearly provide relevant and accurate parameters for further selection and formulation. MBE-300III technical parameters Note: 1. The flow in the table is the data measured when the medium is “water”, and the flow rate of the materials will vary. 2. If the material has poor fluidity, it is recommended to feed the corresponding pump at the inlet. The pumping pressure is P≤0.2Mpa 3. The parameters in the table are subject to change without prior notice. The actual product shall prevail.