The RB Series ribbon mixers are available in multiple thread shapes. Specifically, it can be selected from the nature of the material and the location of the discharge. For materials with high viscosity and poor flow performance, the scraping device can be added on the basis of the original screw. The PTFE plate scrapes the wall of the tube in the circumferential direction to solve the problems of adhesion, agglomeration and blockage of the inner wall remelting material, and improves the efficiency of subsequent operations. RB continuous strip (bottom center discharge) This design of the thread can quickly achieve a homogeneous mixing effect. The outer thread rod pushes the material to the center position, and the inner screw rod pushes the material to both ends, rotating clockwise or counterclockwise to make the material move radially, opening the bottom center discharge valve, and unloading the material very quickly. material. RB continuous thread (bottom discharge) A continuous strip for one or two discharges at the bottom that can be discharged at the bottom left or bottom right of the barrel. The outer strip pushes the material to the bottom of the discharge, and the inner strip can also push the material to the bottom of the discharge, which causes the material to move radially. RB broken type screw (bottom center discharge) The material moves in the same way as the continuous spiral strip, and is widely used for uniform mixing of high-density, multi-powder, and large-area materials. RB paddle blade This hybrid design is an excellent choice when the machine is used for incomplete or complete batch operation, and the most efficient mixing results are obtained with minimal load. RB scraper type V-shaped thread Suitable for mixing materials that require scraping. T-shaped strip The RB T-shaped strip is suitable for mild materials and does not overheat the heat sensitive material.